Detailed maintenance of six parts of road roller accessories

1. Maintenance of main clutch of roller accessories
In addition to carefully adjusting its control mechanism at any time, XCMG accessory main clutch shall also carefully check and adjust the ends of its three release levers located in the same plane, and maintain a certain clearance (0.4 ~ 0.7mm) with the release bearing. When the main clutch is engaged and disengaged, it should be smooth and gentle without excessive force. When the clutch is engaged, the clutch pedal should be returned to the original position to fully engage the clutch. When the clutch is disengaged, the keyword ranking should be optimized. The pedal should be pressed to the bottom to fully disengage the clutch. During the operation, the construction company of the website needs to prevent the clutch from being in a half clutch and half engagement state to avoid burning out the clutch. Check the main clutch frequently to avoid oil contamination on the surface of the friction plate and pressing plate.
2. Maintenance of hydraulic system of roller accessories
Check whether the mounting bolts of filter, valve, motor, oil pump, oil cylinder, etc. are loose and whether there is oil leakage at each joint. Observe the oil level gauge on the side of the oil tank. When the hydraulic oil of the small roller is too small, add the filtered hydraulic oil of the same brand. The hydraulic oil tank shall be cleaned every six months and the oil shall be changed. When adding or changing oil, do not mix impurities and dirt into the oil tank. The new oil added or changed shall be filtered in advance. No. 68 anti-wear hydraulic oil is used for hydraulic oil. The hydraulic oil filter shall be cleaned or replaced every 500 hours of use.